Why is water not coming out of my Shampooer?
It’s possible your pump may have lost its prime. To check, turn off machine and hold the spray trigger for 30 seconds. Your pump belt could be broken. To check, turn the power off and unplug from the outlet, insert a flat head screwdriver in to the slot of the belt access door to release.
Why isn’t my Bissell Proheat will not suction?
Check to see if the collection water tank outside the bladder is full. The float will activate to cut off suction. Empty the collection tank and test for suction. If there is still no suction at this time, please visit a BISSELL Authorized Service Center.
Why does my Bissell Proheat 2x not suction?
Your dirty water tank may not be secured tightly. Check the rubber tab on the dirty water tank and press firmly on all edges to secure it tightly. The accessory hose door also needs to be closed securely. Check the door and make sure it is locked in place.
Why is my Bissell vacuum not suctioning?
Check to make sure the Vacuum Suction Knob is turned towards “Floor Suction.” Or there could be large debris clogging the brush roll rotation. Your dirt container may not be seated properly or may be full. Check your hose for any cracks or holes that can cause loss of suction.
Why isn’t my Hoover Smartwash not picking up water?
Empty the dirty water tank Lift the tank off and pour the water down the drain. Re fit the empty tank and resume cleaning. Once the tank is full a safety float switch will prevent the cleaner sucking up any more water which may harm the motor. Re fit the empty tank and resume cleaning.
Why won’t my Bissell carpet cleaner turn on?
Unplug, and check the end of the hose, tool, and inside the dirt water tank stack and remove any clogs. Let the unit sit unplugged for 30 minutes after removing any clogs for the thermal protector to cool and reset automatically. Then test in a working outlet.
Where is the Bissell CrossWave reset button?
Error: Stuck in a Firmware Loop
- Check App Version. Click the Hamburger menu in the top left corner of the BISSELL Connect App. Choose Account on the bottom of the menu.
- Perform a factory reset. Hold down the gear button on the machine for 20 seconds, until you hear 2 beeps.
- If this continues Contact Us.
Why is my Bissell CrossWave not picking up water?
First, make sure your CrossWave® is turned OFF and not sitting on the 3-in-1 Docking Station. Check the dirty water tank and make sure there are no clogs in the hose below it. Check for any build up or clogs in the area leading up to the dirty water tank and remove if necessary.
What should I do if my Bissell carpet cleaner is not working?
Occasionally, the Bissell Carpet Cleaner may fail to dispense the cleaning solution to the flow being cleaned. When this happens, you are advised to take the following troubleshooting steps. Unplug the machine from the wall power socket and switch it off.
What should I do if my Bissell Water tank is not full?
Follow these easy steps to fix the problem. Step 1. If you mark that the soap solution is not spraying, turn off your Bissell carpet cleaner as early as possible. Step 2. Remove the tank and set it aside. If the water tank was installed imperfectly, the soap solution will not spray. Step 3. Make sure that the water tank is full.
What to do if your Bissell ProHeat brush is not spinning?
If your Bissell proheat 2x brushes are not spinning. Then follow these steps to fix the problem. First, make sure the pod is properly seated on the machine. Next, check if the brush roll switch is turned on; you will know when the switch lights up.
How do you turn off brush roll on Bissell vacuum?
The brush roll will only run if the machine is reclined and it will automatically turn off when the vacuum is in an upright position. To recline place your foot on the base of a vacuum then pull back and push down on the handle. If these steps didn’t work you’ll have to check the brush roll itself.
