What is broadcast limit?

What is broadcast limit?

This is the theoretical maximum of network bandwidth in per cent that can be used for broadcast and multicast traffic. Any broadcast or multicast limit exceeding that limit will be dropped.

How do I change the port speed on my HP switch?

Enabling or disabling ports and configuring port mode (CLI)

1. You can configure one or more of the following port parameters.
2. See Status and parameters for each port type.
3. To configure port C5 for auto-10-100, enter this command: HP Switch(config)# int c5 speed-duplex auto-10-100.

How do I set up ProCurve?

How to: Configure a HP ProCurve switch

1. Step 1: Connect your serial connection.
2. Step 2: Conenct PuTTY.
3. Step 3: Get the IP address.
4. Step 4: Set time server.
5. Step 5: Set SNMP community info.
6. Step 6: Launch the web GUI.
7. Step 7: Configure basic info.
8. Step 8: Create VLANs.

What is broadcast in Whats App?

Open WhatsApp messenger on your device. Go to the options button in the top right-corner of the screen and select New Broadcast List. Type in the names of the people that you want to include in the message. You can add up to 256 contacts. Press the create button.

How do I reduce broadcast traffic on my network?

They are:

1. Make smaller broadcast domains.
2. Use multicast to unicast conversion (if available with your AP vendor)
3. Increase multicast transmit rate (this should be used cautiously)
4. Dynamic multicast rate adjustment (if available with your AP vendor)

How do I turn off the port on my HP Procurve Switch?

To disable a port on the HP V1810 switch, open the web GUI interface and select Switching, Port Configuration. On the Port Configuration screen, there is an option for Admin Mode which allows a port to be disabled or enabled. The port is enabled by default.

How do I connect my HP ProCurve Switch?

To connect a console to the switch, use the console cable shipped with the switch and connect a PC or VT-100 terminal to the console serial port….

1. Reconfigure the switch and save the new settings.
2. Reconfigure the terminal and save the new settings.
3. Reboot the switch and re-establish the console session.