What do eaves trays do?

What do eaves trays do?

Fills the gap between the roofing membrane and and the gutter system. The eaves protector trays are a cost effective solution to help prevent rot or damp. In the past, thick and heavy layers of roofing felt were used between the rafters and the tiles that make up your roof. …

What are eaves carriers?

Eaves Carrier / Support Trays are designed to bridge the rafters and provide support for the roofing felt. It eliminates the problem of rotting felt caused by the sagging and retaining of water by the felt at low-level eaves.

What is a drip tray on roof?

Description. This product is sometimes known as an Eaves Tray or Drip Tray. These uPVC Felt Replacement are 1.5 Meters long and are designed to fit under the existing felt or act as a replacement on new installations at the bottom row of roofing.

How far should eaves overhang?

Overhangs can vary from a few inches to a few feet depending on preference; however, the suggested width of an overhang is between 12” and 18” for eaves and no more than 8” for rakes. That said, overhangs can extend as far as 2′ without the need for external supports.

How much does it cost to install eaves?

Roof Eaves Repair

Roof Eaves Repair Cost
National average cost $900
Average range $460-$1,330
Minimum cost $180
Maximum cost $4,100

How do you seal eaves?

How to Seal Eaves

  1. Step 1: Measure Eave Lengths. Before you order the eave lining, measure the length of the roof eaves you will be sealing to ensure you order the right amount.
  2. Step 2: Cut Lining. Cut the lining sheets to the lengths you need.
  3. Step 3: Install Lining.

Should roof felt go into guttering?

The bottom course of felt on a roof, called Sarking Felt, ensures that all of the rainwater is correctly channeled into the gutter by protecting the eaves from any wind-driven rain. Sarking felt when correctly installed should hang down inside the gutter.

How far can rafters overhang?

Two feet is the general maximum length for a typical roof overhang. This will protect a roof from most types of damage. Roof overhangs can extend farther than 2 feet, but beyond this length, they begin to lose structural integrity and require external support.

What is the standard width of eaves?

As a rule of thumb, eaves width should be 45% of the height from the window sill to the bottom of the eaves.

Do roofers replace eaves?

Roof repairs typically involve replacing damaged shingles and rusted flashing, but the overhang of a roof is often the first area to succumb to rot, peeling paint and other weather-related problems. The good news is, unlike most roof repairs, you can fix an eave or gable overhang (rake) without climbing onto the roof.

What’s the purpose of an eaves carrier tray?

Eaves Carrier / Support Tray 1500mm. Eaves Carrier / Support Trays are designed to bridge the rafters and provide support for the roofing felt. It eliminates the problem of rotting felt caused by the sagging and retaining of water by the felt at low-level eaves.

How are felt support trays used on roofs?

Watch our short video for an introduction into felt support trays and how they are used to protect the eaves of the roof when replacing rotten felt. Felt support trays are probably the most important felt parts of a roof, as they are what allows the rain water to run into the gutter.

Why do I need an underlay support tray for my eaves?

A simple and effective product to prevent the exposure of the roofing underlay at the eaves, which leads to long-term degradation of the underlay. The Underlay Support Tray, due to it‘s rigid nature, prevents ponding behind the back of the fascia board.

Back To Top