How do you sew a sleeve placket?

How do you sew a sleeve placket?

Turn the placket to the right side of the sleeve and gently press the seams flat to smooth out any possible wrinkles. 8. Fold the narrow side of your placket along the line slightly covering the line of stitching. Press and pin.

Which placket is used on mens shirts?

There are four types of plackets for the modern man, which serves different roles in making a shirt: buttoning with no front placket, buttoning with placket, hidden buttons and popover.

What is a placket on a shirt?

The shirt placket refers to the part of your shirt where the buttonholes are placed. Located at the center front, plackets are almost always made with more than one layer of fabric. In the past, plackets were entirely separate pieces of cloth that were sewn to the front; today, the edges are simply folded.

Where do you place the placket on a shirt sleeve?

Next, place the right side of the placket on the wrong side of the shirt sleeve, lining up the two clips you’ve made on the sleeve and the placket pieces. With wrong sides up, place the placket on the shirt sleeve, aligning the the clips on both pieces, as shown in this image on the left shirt sleeve and its corresponding placket.

How to sew professional sleeve plackets-threads magazine?

Starting at the folded raw edge of the placket overlap, edgestitch horizontally, then up along the edges of the peaked roof, and back down, securing the outer fold to the sleeve. Note: Make sure you are not stitching down the opening of the placket and are stitching the folded-under raw edge.

How big should the placket be for a mens shirt?

If you’re using interfacing for the front placket, cut two strips measuring the finished placket width (1 1/4″ is standard) by the length of the front edge, minus five inches.

How big does a sleeve placket need to be?

If you examine ready-to-wear shirts (I’m using men’s shirts as examples, but this applies to many women’s shirts as well), the sleeve placket is generally standard. The overlap part of the placket, with the peaked roof, is roughly 6 inches long and 1 inch wide.

Back To Top