How do I reprogram my genie Intellicode wireless keypad?
To Program the Intellicode Wireless Keypad
- Open cover fully by sliding keypad cover up until it latches.
- Press 3-5-7.
- Press “PROG”. ( red light blinks)
- Enter your Personal Identification Number (PIN).
- Press “PROG”. ( red light blinks fast)
- Close cover fully.
- Proceed to Part 2 below.
Do I have Intellicode 1 or 2?
To determine if the opener is Intellicode 1 or Intellicode 2, check the color of the learn indicator light on the opener.
How do I reset my Genie garage door opener keypad?
1. Press and hold both the Program key and the Up/Down key for about 5 seconds. The LED will slowly blink and then go out. When the LED goes out, you have successfully erased the old programming.
How do I reset my genie Intellicode keypad?
To erase your old PIN, press and hold down the following buttons in order: program, 6 and Up/Down arrow. Once the red light blinks once and stops, release the buttons. To reset this keypad, press and hold down the program button, then the “6” button and then the Up/Down arrow key.
How do I reset my genie Intellicode pin?
Changing a PIN
- Open cover fully.
- Enter PIN to be changed.
- Press PROG. Indicator will blink once per second.
- Enter new PIN.
- Press PROG.
- Indicator will blink twice if PIN 1 has changed or go out if PIN 2 was changed.
- Close cover. Your keypad is now ready to be programmed to the garage door opener.
How do I find my genie Intellicode model?
Most Genie garage door openers also have the model number under the light bulb cover on the power head or on the back panel. A lot of the newer Genie models also have the model on the outer cover of the power head, making it easy to tell which model you have from the ground.
Why is my Genie garage door opener flashing red?
The garage door won’t open or close You’ll know that the sensors are the culprit if the little red lights on them start flashing. This could mean one of the following things: There’s something blocking the sensors. The photo-eye lenses are dirty.
Is the Genie Intellicode transmitter compatible with the keypad?
It is NOT compatible with Genie Intellicode transmitters (if your keypad has Intellicode printed on the cover, go to the next set of programming instructions below). The Door Code in the Step-By-Step Procedure at right is determined by the internal code switches inside your transmitter and the accompanying chart.
How to program a Genie garage door opener?
Unlock the programming feature on your garage door opener by using one of your existing remotes and pressing it only once. While the purple light is blinking go to the keypad and enter your programmed PIN and press the Up/Down arrow key 3 or 4 times, until the door activates. Programming Genie Hardwired Keyless Entry Pad (KEP1).
Where is the learn Code button on Genie garage?
Gently press and release the radio receiver Learn Code button on the motor head in your garage to start the red indicator light next to the button will start blinking. This small black button is always found near the floppy antenna wire and is usually behind the light cover for your light bulbs.
What are the code switches on the Genie remote?
This keypad works with remotes having either 9 or 12 internal code setting switches and 390 frequency. The keypad is black with a slide-up cover showing the Genie logo only. Notice the star and # switches.
