What is a 4 pin connecter?
The P4 connector is a 12V power supply cable used with motherboards that have an Intel Pentium 4 or later processor. Today, the connector is a standard power connector and is used with both Intel and AMD motherboards. All of these wires attach to a four pin connection on the motherboard.
How do I identify DC connectors?
Listing of DC coaxial connectors Connector size is often listed in the format OD (outer diameter) × ID (inner diameter) × L (length of barrel) and expressed in millimeters. Designations may vary between manufacturers. Coaxial plugs that have a male center pin will have another measurement, Center Pin Diameter (CPD).
What is the function of 4 pin Molex P4 12V?
This Motherboard P4 12V 4-Pin to Molex 4-Pin Power Adapter Cable is used when you want to upgrade your system to a Pentium 4 (P4) system. Using this cable allows you to upgrade without having to buy a new power supply.
What is the function of 4 pin Berg connector?
the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a “floppy power connector”, but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).
What are the different types of DC connectors?
In the electronics industry, there are three commonly accepted configurations for DC power connectors: jack, plug, and receptacle. A DC power jack is responsible for receiving power and is usually mounted on the PCB or chassis of an electronic device.
How do you identify a barrel connector?
When ordering, there are three differentiating characteristics of a barrel connection- inner diameter (the diameter of the pin inside the jack), outer diameter (the diameter of the sleeve on the outside of the plug), and polarity (whether the sleeve voltage is higher or lower than the tip voltage).
