Do you have to break in a new Mercury outboard?
With a new motor, however, it will pay to walk before you run wide open. Exercise a little restraint and follow the break-in procedure devised by Mercury engineers, and your new motor can deliver a lifetime of dependable performance.
Do you have to break in a 4 stroke outboard?
All current Yamaha four-stroke motors require a period of 10 hours break-in. The first 10 hours of operation should be run using the following running pattern. 1. First hour – run the motor at varying speeds up to 2000 rpm (approximately half throttle if there is no tachometer).
How many hours can a Mercury outboard last?
Mercury motors claim to last thousands of miles, but like all other motors, this depends on the care, maintenance, and use. With the proper care and cleaning, Mercury outboard motors could offer you over 2,000 or even 3,000 hours of use.
What happens if you don’t break in outboard?
Failure to follow the “break in procedure” for an outboard motor can result in mechanical failures, reduced life of the outboard and even a voided warranty!
How fast will a 115 hp Mercury outboard go?
The combination of the lower gear ratio and larger blade diameter of the Enertia’s three-blade stainless steel wheel enabled the Scout to hit a top speed of 43.6 mph at 5,800 rpm, with superb 5.4-mpg fuel efficiency at 4,000 revs, hitting 25.9 mph at 4.8 gph.
How many hours should a 4 stroke outboard last?
A typical two-stroke or four-stroke outboard engine should provide 1,500 hours of run time. Based on the average use of 200 hours per year, this will last 7-8 years. However, changing your oil every 50 hours of operation and regularly flushing the engine can see your outboard engine last 10 to 20 years.
How many hours does it take to break in a new boat motor?
The rule of thumb for most marine engines are 10 hours for the break-in period. Some inboards require more, like a 20-hour break in, but I think this could go back to the debate of the “break-in period myth.” So we will leave that there with what the manufacturers want, and say.
Is 1000 hours a lot on a boat?
The number of hours that a marine engine runs is very dependent on the amount and quality of maintenance over the years. The typical gasoline marine engine will run fine for the first 1,000 hours. It is at this juncture that the engine starts to exhibit small problems.
How many hours does it take to break-in a new boat motor?
What’s the break in procedure for a Mercury fourstroke?
Mercury FourStroke Engine Break-in Procedure: 115-150hp Pro XS. A proper outboard engine break-in is one of the most important steps to ensure reliable performance and a long life from your outboard. Wired2Fish’s Mitch Anderson walks us through the break-in procedures for a new Mercury 150hp Pro XS FourStroke.
What are break in procedures for Mercury Marine engines?
Engine Break In Procedures for Mercury Marine. BREAK-IN PROCEDURES. “Break-In” Procedures for 4-cycle MerCruiser Engines. IMPORTANT: The first 20-hours of operation will have a dramatic affect relative to overall engine performance and expected engine life. Proper break-in practices reduce the potential for excessive oil consumption.
Is it easy to break in a new Mercury outboard?
Follow this easy process for longer engine life. The owner of any brand new Mercury outboard motor will find it hard to resist the temptation to immediately drop the throttle and feel the sensation of smooth, unrelenting power. With a new motor, however, it will pay to walk before you run wide open.
What kind of engine does a Mercury fourstroke have?
A helpful video for maintaining your 75-115 FourStroke Engine. A helpful video for maintaining your 75-115 FourStroke Engine. Find out more about Mercury’s distribution partners, sponsorship applications, and our global locations.
